Disk read speed always shows 0

[warlock00]

Disk read speed always shows as 0 in various UIs

Also shows up as 0 in various Docker UIs such as Glances.

[TMLila]

Hello!
Thank you for contacting TerraMaster!

Regarding the issue you mentioned about the disk read speed always showing 0, the following is recommended:

1. Perform a file transfer test: Try transferring files from the NAS to the computer or from the computer to the NAS and observe any fluctuations in disk read speed. Also, check the Docker container configuration to make sure that there are no limitations on disk I/O. 2.

2. Check disk health: You can use a tool such as CrystalDiskInfo to check the health of the disk for bad sectors or other problems. Or run the Windows chkdsk command to detect and repair disk errors.

If the problem is still not resolved after trying the above methods, it is recommended that you contact the TerraMaster Technical Support team to provide more detailed information for further analysis and resolution.

[EvertJenkins]

Disk read speed always shows as 0 in various UIs

Also shows up as 0 in various Docker UIs such as Glances.

Block Blast

I have also encountered this case recently. The program error and always displaying 0 is very frustrating for users.

[EvertJenkins]

Disk read speed always shows as 0 in various UIs

Also shows up as 0 in various Docker UIs such as Glances.

Block Blast

I have also encountered this case recently. The program error and always displaying 0 is very frustrating for users.

If you find a method, please remind me.