NUT UPS configuration

[fedex03]

Hi there,

I have my UPS connected to a server running NUT to get information form my UPS.

I'm looking for a guide to configure my F2-424 to read UPS information from NUT.

In the Hardware and power configuration I enabled the "UPS Support" and selected "TNAS UPS server" as UPS type, but I cannot access to the UPS information.

Any help?

Thanks in advance for your help!

[Gremlin]

Presume you input server ip into TNAS setup.

Configuration of TNAS is limited (to none existent) for NUT. You may be better off setting up TNAS as server (with UPS connected to TNAS via USB) and then point the server at the TNAS.

[outkastm]

If not mistaken and remember correctly, UPS function on TOS is based on NUT.

Here is working fine, standard setup in TOS:

2024-01-30 08_08_04-TOS 5.1.png

And here the config of NUT server running on HomeAsistant machine with UPS connected to it.

2024-01-30 08_14_09-Home Assistant.png

[fedex03]

If not mistaken and remember correctly, UPS function on TOS is based on NUT.

Here is working fine, standard setup in TOS:

2024-01-30 08_08_04-TOS 5.1.png

And here the config of NUT server running on HomeAsistant machine with UPS connected to it.
2024-01-30 08_14_09-Home Assistant.png

Thank you for the reply.

I configured the NUT as you, the only difference is the user.
I defined the following users:

• upsadmin

• upsmaster

• upsuser

Maybe this is the cause.

Let me try to add the user like you.

Thank you!