Hi everyone,
I installed TOS 6 on SSD only (removed all HDDs during setup), then reinserted the HDDs and created a storage pool. At first everything was quiet, but after a few reboots, one HDD now has constant activity even when idle.
Is TOS 6 copying system partitions to the HDDs automatically? How can I force it to keep system data strictly on the SSD? Any advice would be appreciated!
[Help] TOS 6 Still Writing System Data to HDD After SSD-Only Install?
-
DebraJSimpson
- Posts: 1
- Joined: 04 Mar 2026, 17:17
Re: [Help] TOS 6 Still Writing System Data to HDD After SSD-Only Install?
TOS6 won't copy system partitions to non-system disks automatically.
You can use the `hdparam -Y` command to put the hard drive into hibernation mode.
Additionally, you can use the following command to check who is waking the HDDs: `blktrace -d /dev/sdX -o - | blkparse -i -`
You can use the `hdparam -Y` command to put the hard drive into hibernation mode.
Additionally, you can use the following command to check who is waking the HDDs: `blktrace -d /dev/sdX -o - | blkparse -i -`
To contact our team, please send email to following addresses, remember to replace (at) with @
Technical team: support(at)terra-master.com(for technical support)
Service team: service(at)terra-master.com(for purchasing, return, replacement, RMA service)
Technical team: support(at)terra-master.com(for technical support)
Service team: service(at)terra-master.com(for purchasing, return, replacement, RMA service)