Hello,
I purchasing a f5-422 last month, and I operate it with single mode hard drive, today I perching 2 4TB HDDs, I turn off the device and unplug the single drive and install the two drives, but the device never shown in network, I connect monitor to HDMI and sees this message Reboot and Select Proper Boot Device.
What can I do to re setup the device.
[Discussion] What can I do to re setup the device.
Re: [Discussion] What can I do to re setup the device.
Please attempt to boot up the F5-422 without installing any HDDs, then try searching for and accessing it again, and pay attention to the content displayed on the HDMI monitor at the end.
To contact our team, please send email to following addresses, remember to replace (at) with @:
Technical team: support(at)terra-master.com (for technical support)
Service team: service(at)terra-master.com (for purchasing, return, replacement, RMA service)
Technical team: support(at)terra-master.com (for technical support)
Service team: service(at)terra-master.com (for purchasing, return, replacement, RMA service)