TerraMaster Forum

Hi All,

I have an F2-423 with dual 2.5gb LAN ports. When connected to the network as individual ports there are no issues. When I bond them together I get an ARP storm of 131,000+ request every 10 minutes.
When bonded the TNAS auto changed the IP address from a 192 address to a 169 address with a subnet mask of 255.255.0.0. Even though the bonded IP address is in a completely different range, the original IP of the first port still gets me to the admin page. I can't log in (or even ping) the 169 address.

Do I need to manually change the IP and subnet to something within the 192 address range?

Different story, similar ending. Welcome to the club:

viewtopic.php?t=7472

colsanders83 wrote: ↑21 Feb 2025, 00:00 Hi All,

I have an F2-423 with dual 2.5gb LAN ports. When connected to the network as individual ports there are no issues. When I bond them together I get an ARP storm of 131,000+ request every 10 minutes.
When bonded the TNAS auto changed the IP address from a 192 address to a 169 address with a subnet mask of 255.255.0.0. Even though the bonded IP address is in a completely different range, the original IP of the first port still gets me to the admin page. I can't log in (or even ping) the 169 address.

Do I need to manually change the IP and subnet to something within the 192 address range?

Hello! Regarding the issue you are experiencing, you can try the following steps to resolve it:

1.Use TNAS PC to change the IP: Attempt to change the IP address to a range starting with 192 through TNAS PC.

2.Restart the device: If TNAS PC cannot change the IP, try restarting the NAS device. If the issue persists, it is recommended to restart the router.

3.Direct connection to the computer: Connect the NAS directly to the computer. TNAS PC will display an IP address starting with 169, which you can use to log in to the NAS.

If none of the above methods resolve the issue, please contact us promptly. If the issue has been resolved, please enter the system and send us the logs so we can further analyze the cause. Thank you.

Method to send logs: Go to the "Support & Help" module, generate a report on the "Issue Feedback" page, and send it to our technical support email.

Thank you again for your support and understanding!

Thanks for the guide!