Brand new F2-423 and TRAID Pool Capacity
Posted: 17 Oct 2024, 23:22
Hi, I;m new here. Hope this post in the right forum.
Newly purchased F2-423 (with latest TOS FW) populated with 2 disks (2 x 6TBs).
Initialized went well with TRAID and BTRFS after evrything done I only get 688GB poool capacity?
Long story short, delete volume , re-initialized pool same thing happened as before which is 688GB capacity.
Talked to online tech support was asked to take screenshots of the issue.
Tried re-initialized still the same issue.
Currently I'm on RAID1 which shows full capacity (5.45TB) which is right for the configuration and everythinf works flawless.
For the life of me I prefer run on TRAID knowing that I could add a bigger capacity disk in the future.
If anyone could shed some light on the issue ...appreciated. TIA.
Newly purchased F2-423 (with latest TOS FW) populated with 2 disks (2 x 6TBs).
Initialized went well with TRAID and BTRFS after evrything done I only get 688GB poool capacity?
Long story short, delete volume , re-initialized pool same thing happened as before which is 688GB capacity.
Talked to online tech support was asked to take screenshots of the issue.
Tried re-initialized still the same issue.
Currently I'm on RAID1 which shows full capacity (5.45TB) which is right for the configuration and everythinf works flawless.
For the life of me I prefer run on TRAID knowing that I could add a bigger capacity disk in the future.
If anyone could shed some light on the issue ...appreciated. TIA.