TerraMaster Forum

Hello

I have this issue that you can see on the screen shoot.
I have sync the date/time yesterday but after some hours this happens

The time on the system is ok
The time on the GUI is not OK.

Is there any way to correct this?
I want the info,ation on the GUI to be correct.

Second Issue:
I am not able to cut and paste the info on the GUI.
For exemple : I was not able to get to "Cut" the Model on the GUI. It does not allow. Its like if it was an image.

If you keep the front-end web page of TOS open, the time on the page will be counted by the web cumulative count. When you jump to other pages, the system resources of the TOS page will be limited to a minimum, causing the count to slow down. You only need to refresh the page to get the latest system time.

We will try to optimize this in the future new releases.

OK, I understand.

Anyway the page should read the system date/time.
It would be much better.

TMzethar wrote: ↑07 Oct 2023, 18:14 We will try to optimize this in the future new releases.

About time

Additionally, a minor point, but on the latest TOS for the F2-210, when GMT is selected in the control panel the summary line shows the zone as IST, and so does the GUI.