TerraMaster Official Forum

Hi.

It's been a while since I created my shared folders and I'm not sure if they are encrypted or not. As a test, I created a test encrypted shared folder and then viewed the shared folder list but it doesn't specify whether it is encrypted. It just looks like any other folder...

Is there a way I can tell which folders are encrypted?

Thanks.

ckl wrote: ↑12 Jul 2023, 13:07 Is there a way I can tell which folders are encrypted?

One way to figure this out would be that Encrypted Folders require key entry after a restart of TOS.

Beyond the additional menu in TOS itself, there isn't currently a visual representation to quickly identify them.

crisisacting wrote: ↑12 Jul 2023, 15:46 there isn't currently a visual representation to quickly identify them.

Nor would you necessarily want it. Encrypted folder says "Here is something I want kept private". Identifying such to the casual scanner says "Here is something worth an attempted hack".

Gremlin wrote: ↑12 Jul 2023, 15:51

crisisacting wrote: ↑12 Jul 2023, 15:46 there isn't currently a visual representation to quickly identify them.

Nor would you necessarily want it. Encrypted folder says "Here is something I want kept private". Identifying such to the casual scanner says "Here is something worth an attempted hack".

On the TOS interface itself, a differentiating icon/marker/description would be helpful.

From the protocol aspect, definitely show all folders similarly; unless it's set to public without credentials, every share should already require username+password.

After upgrading my TNAS F2-221 from version 5.1.24 to version 5.1.40, on reboot i have 3 beeps and after whe acessing using the browser it gives a "No hard drive detected" message and goes to "Initialization" page.
No ssh or smb access working.
What can I do?

migas wrote: ↑16 Jul 2023, 07:18 After upgrading my TNAS F2-221 from version 5.1.24 to version 5.1.40, on reboot i have 3 beeps and after whe acessing using the browser it gives a "No hard drive detected" message and goes to "Initialization" page.
No ssh or smb access working.
What can I do?

Have you ever used TOS4? The system partition may be small and there may be an upgrade issue. (Please refer to the red note on the first page) Please try installing TOS 5.124 back.

Just to give feedback: I've just bought a new F2-223, booted and let it init with default config (scratch install I suppose).
At first restart the bootloader complained for missing file, i.e. setup.symbol `grub_fshelp_find_file_lookup` not found
To make it boot again I had to enter BIOS bootloader section and change disks order, moving the internal storage before HDD.

TOS version: 5.1.40
BIOS/initBoot version: 5.19

Yep, the same i had with the previous version: viewtopic.php?f=28&t=4733&p=27361#p27361

Unfortunatly, my T9-450 dont have an HDMI port to see the error, i had to find out how to use the console port

Thomas

Updated from 5.1.33 without any issues.

My TNAS was updated and now I could not access it after updating. I regret buying this piece of crap. It should work smoothly after each update, rather than users have to spend time to search on problems before each updating. Such a PITA !