PiHole docker resets when NAS is rebooted
Posted: 19 Jul 2022, 13:24
Hello all,
I searched the forums and maybe missing it.. I have a F4-210, 4.2.31 firmware.
I can install pihole in docker. It runs fine. But when I restart the NAS, all settings are gone - back to default. And no changes save - ie I go into DNS, add a few dns servers, hit apply, sceren says saved, but it's not.
I tried adding
/pihole_app
/dns_config
and volumes, but that didn't fix it.
Any suggestions on what I'm missing?
Thanks
I searched the forums and maybe missing it.. I have a F4-210, 4.2.31 firmware.
I can install pihole in docker. It runs fine. But when I restart the NAS, all settings are gone - back to default. And no changes save - ie I go into DNS, add a few dns servers, hit apply, sceren says saved, but it's not.
I tried adding
/pihole_app
/dns_config
and volumes, but that didn't fix it.
Any suggestions on what I'm missing?
Thanks