Re: TD-2 Thunderbolt 3+ Setup Issue (MBP 2019, OSX 11.5.1)
Posted: 20 Aug 2021, 18:42
Hi！
1. When creating RAID, D2 must be turned on, and D2 must be connected to the computer through a lightning cable. After turning the knob to the designated RAID position, you need to press the "RESET" to make the RAID take effect. After taking effect, you need to erase the disk again to find it in the Finder.
2. Sync the data in iCloud to D2. When syncing, you can point the location of the computer to the external storage device D2.
3. D2 can create RAID1. In this mode, if one of the hard drives is broken, the data can still be accessed normally.
1. When creating RAID, D2 must be turned on, and D2 must be connected to the computer through a lightning cable. After turning the knob to the designated RAID position, you need to press the "RESET" to make the RAID take effect. After taking effect, you need to erase the disk again to find it in the Finder.
2. Sync the data in iCloud to D2. When syncing, you can point the location of the computer to the external storage device D2.
3. D2 can create RAID1. In this mode, if one of the hard drives is broken, the data can still be accessed normally.