When I initialize my device, I cannot click next or skip after setting my my username and password and request the verification code.
Or even if I successfully complete the setup, the array formatting stays at 10% or 60%.
Applicable models: all TNAS models.
Applicable version: TOS4.x
Instructions:
Note: Please do not use this guide if you have data on your hard drive.
1. Log in to the SSH terminal: viewtopic.php?f=75&t=2350
2.
Code: Select all
mdadm -S /dev/md0
Code: Select all
ls -l /dev/sd*
Code: Select all
mdadm --zero-superblock /dev/sdb4
Code: Select all
rm /etc/mdadm.conf