Page 1 of 1
IHM-Notification Error
Posted: 20 Mar 2021, 06:21
by fpsking
Hi so i just got the F4-210 and 2 new Seagate 4 TB IronWolf 3.5 Inch Internal Hard Drives but on one of the drives i am getting IHM-Notification i have had a look and i seen wait 24hrs and it may fix its self but i have waited and its still giving the error.
Any ideas as to why this is i have also done a bad block scan also the drives are set up as single drives.
Re: IHM-Notification Error
Posted: 20 Mar 2021, 13:02
by TMS
Hi,
1. Power off the TNAS device, unplug and plug the hard disk , will it recognize the error after turning on the device?
2. Power off the TNAS device， Put HDD2 into HDD1 slot,HDD1 into HDD2 position then turn on the device （or other hard drives）. Is the recognition normal?
3.The S.M.A.R.T tools list in the TOS UI is not powerful enough to determind if your hard disk is really healthy.
To have a full scan for your drive, you need some professional tools refer to this link:
viewtopic.php?f=75&t=1125
Re: IHM-Notification Error
Posted: 21 Mar 2021, 20:50
by fpsking
Swapping the drives around did the trick
