Page 1 of 1
First use D2
Posted: 12 Nov 2020, 23:36
by Kiedriek
Hi, I just recieved the D2, I connected it to my MacMini 2018. It's recognized by the computer. I inserted just 1 ssd, and thought it would work but the red lights keep flashing.
Does it only work with 2 ssd's inserted? Or is the D2 not in single mode.
Thanks for answering!
Re: First use D2
Posted: 20 Nov 2020, 16:41
by TMSupport
Step 1: Keep the device connected to the computer, powered on and diskless (no hard disks installed);
Step 2: Check and ensure the pointer at the back of the device at the Single mode, then press and hold the “Reset” button for 10 seconds;
Step 3: The hard disk indicators will be off, then keep the device powered on and install the hard disks;
Step 4: The hard disks should be then showing up in Windows “Disk Management” or Mac “Disk Utility”. Please initialize and format the disks to use.