Page 4 of 4

Re: TOS 7.0.1536 (x86) Official Release Update

Posted: 15 Nov 2026, 20:04
by Crashoveride
Additional experiment: SMB Multichannel with one 10GbE Mac adapter and two 5GbE NAS ports

Hello everyone,

I'd like to share the results of another experiment with my TerraMaster F4-425 Pro running TOS 7.

After receiving my TP-Link TL-SX105 V4.0 10GbE switch, I attempted to configure SMB Multichannel using both 5GbE interfaces on the NAS and a single 10GbE adapter on my Mac mini M4.

The configuration was based on this TrueNAS community article:
https://forums.truenas.com/t/lacp-smb-n ... tion/35232

The author reported successfully combining two 2.5GbE NAS connections through a single 10GbE Mac interface using two IP addresses on separate subnets.

My configuration

- Mac mini M4 with ACASIS NT0201 Thunderbolt 10GbE adapter
- TerraMaster F4-425 Pro with two 5GbE interfaces
- TP-Link TL-SX105 V4.0 unmanaged 10GbE switch
- Mac en10: 10GbE, with two IPv4 addresses (192.168.1.113 and 10.10.10.2)
- NAS eth0: 192.168.1.100, 5GbE
- NAS eth1: 10.10.10.1, 5GbE
- SMB Multichannel enabled on both macOS and Samba

Testing and observations

- The Mac successfully negotiated a 10GbE connection with the switch.
- Both NAS interfaces negotiated 5GbE.
- Both NAS IP addresses were reachable from the Mac through en10, including TCP port 445.
- Samba reported server multi channel support = Yes.
- macOS reported Multichannel ON: yes.
- However, smbutil multichannel consistently showed only one active 5GbE channel, connected to 10.10.10.1.
- The second NAS interface (192.168.1.100) was detected but remained idle.
- I tested transfers in both directions using Finder and ditto, but the second channel was never activated.
- I also checked the NAS network drivers. Both interfaces use r8169, expose a single RX queue, and report receive-hashing: off [fixed].
- The NAS also advertised a Docker bridge interface (172.18.0.1) in its SMB network interface information.

Result

Despite both physical NAS interfaces being available and SMB Multichannel being enabled, macOS continued to use only one 5GbE channel.

I have since reverted to a simpler configuration: one active 5GbE NAS interface, MTU 1500, and SMB Multichannel disabled.

My question to TerraMaster

Is this behavior an expected limitation of SMB Multichannel with the current TOS 7 Samba implementation and network drivers, or should this configuration theoretically support simultaneous connections to both NAS interfaces through a single 10GbE Mac adapter?

I'm particularly interested in whether the reported network interface capabilities or Samba's interface advertisement could explain why the second channel remains idle.

I would appreciate any technical clarification from the TerraMaster team.

Thank you!

Re: TOS 7.0.1536 (x86) Official Release Update

Posted: 15 Nov 2026, 21:53
by CursaYang
Thank you for the additional information; we will share it with our product team for analysis.