TerraMaster Forum

kg223 wrote: ↑22 Jul 2023, 12:20 Updated TOSHIBA 5.1.40 to 5.1.41 everything is fine. VLC started working via UPnP! On 5.1.40 VLC via UPnP did not work.

thumbnailDaemon loaded the processor on 53% , what should I do? The system started working slowly, stopped working transmission

kg223 wrote: ↑22 Jul 2023, 12:41

kg223 wrote: ↑22 Jul 2023, 12:20 Updated TOSHIBA 5.1.40 to 5.1.41 everything is fine. VLC started working via UPnP! On 5.1.40 VLC via UPnP did not work.

thumbnailDaemon loaded the processor on 53% , what should I do? The system started working slowly, stopped working transmission

After about 1 hour, everything returned to normal, the CPU load is 1%!

Installation went very well on F4-420
Thanks

Upgraded F2-221 from 5.1.40 to 5.1.41 with no issues to report

Updated from 5.1.24 to 5.1.41 and uptime still show 149 days! Is this normal? why nas sounds 'beep' but not rebooted?

It is found that your device model is of the previous generation, and it basically uses TOS4. The partition structure from TOS4 is not suitable for the new version of TOS5. Please install it back to TOS5.1.24. Or you can refer to this backup and reset the hard disk: viewtopic.php?f=28&t=4912

TMzethar wrote: ↑01 Aug 2023, 18:33 It is found that your device model is of the previous generation, and it basically uses TOS4.

kidding? it flawlessly run TOS5 since 5.0.x versions for almost an year!

mmalchuk wrote: ↑01 Aug 2023, 17:54 2023-08-01_12-48-51.png

Updated from 5.1.24 to 5.1.41 and uptime still show 149 days! Is this normal? why nas sounds 'beep' but not rebooted?

waiting for a couple hours and issuing the 'reboot' command from the ssh helps)

I have a strange error here. I reset the F2-221 with firmware 5.1.41 and everything works as it should. However, as soon as I enter the start times for my NAS (it starts at different times every day), the transfer rate drops from 113 Mb/s to just 22 Mb/s. I'm starting to despair here. Reinstalled again and everything works until I enter the start times for my NAS. The transfer rate from the Windows PC to the NAS drops again to 22 Mb/s.

You can refer to the link below to troubleshoot the problem: viewtopic.php?f=77&t=527 Or you can try another computer.