Plex Constantly Configuring After Upgrade To 4.2.13

Discussion about Plex and Emby Media Server
Locked
User avatar
petera209
Posts: 6
Joined: 14 Mar 2021, 13:03

Plex Constantly Configuring After Upgrade To 4.2.13

Post by petera209 »

Yesterday I upgraded to 4.2.13 on my F4-210. Since then my Plex works for a little while and then stops working and constantly says it's configuring on the TOS Control Panel. After a few hours it will start working again, only to configure again later. Is this a known issue and is anything being done to fix it?
User avatar
TMSupport
TerraMaster Team
Posts: 2314
Joined: 13 Dec 2019, 15:15

Re: Plex Constantly Configuring After Upgrade To 4.2.13

Post by TMSupport »

Please refer to this link viewtopic.php?f=75&t=364
To contact our team, please send email to following addresses, remember to replace (at) with @
Technical team: support(at)terra-master.com (for technical support)
Service team: service(at)terra-master.com (for purchasing, return, replacement, RMA service)
User avatar
deejc
Posts: 111
Joined: 09 Mar 2021, 03:35

Re: Plex Constantly Configuring After Upgrade To 4.2.13

Post by deejc »

Good luck I ended up recreating mine last time this happened :(
F2-220 WITH 2 x WD RED 2TB RUNNING 4.2.17
Locked