Page 1 of 1

Plex Constantly Configuring After Upgrade To 4.2.13

Posted: 10 Jun 2021, 08:37
by petera209
Yesterday I upgraded to 4.2.13 on my F4-210. Since then my Plex works for a little while and then stops working and constantly says it's configuring on the TOS Control Panel. After a few hours it will start working again, only to configure again later. Is this a known issue and is anything being done to fix it?

Re: Plex Constantly Configuring After Upgrade To 4.2.13

Posted: 10 Jun 2021, 15:25
by TMSupport
Please refer to this link viewtopic.php?f=75&t=364

Re: Plex Constantly Configuring After Upgrade To 4.2.13

Posted: 10 Jun 2021, 15:27
by deejc
Good luck I ended up recreating mine last time this happened :(