Plex Constantly Configuring After Upgrade To 4.2.13
Plex Constantly Configuring After Upgrade To 4.2.13
Yesterday I upgraded to 4.2.13 on my F4-210. Since then my Plex works for a little while and then stops working and constantly says it's configuring on the TOS Control Panel. After a few hours it will start working again, only to configure again later. Is this a known issue and is anything being done to fix it?
Re: Plex Constantly Configuring After Upgrade To 4.2.13
Please refer to this link viewtopic.php?f=75&t=364
To contact our team, please send email to following addresses, remember to replace (at) with @
Technical team: support(at)terra-master.com (for technical support)
Service team: service(at)terra-master.com (for purchasing, return, replacement, RMA service)
Technical team: support(at)terra-master.com (for technical support)
Service team: service(at)terra-master.com (for purchasing, return, replacement, RMA service)
Re: Plex Constantly Configuring After Upgrade To 4.2.13
Good luck I ended up recreating mine last time this happened
F2-220 WITH 2 x WD RED 2TB RUNNING 4.2.17