Plex Constantly Configuring After Upgrade To 4.2.13

Discussion about Plex and Emby Media Server
Post Reply
User avatar
petera209
Posts: 15
Joined: 14 Mar 2021, 13:03

Plex Constantly Configuring After Upgrade To 4.2.13

Post by petera209 » 10 Jun 2021, 08:37

Yesterday I upgraded to 4.2.13 on my F4-210. Since then my Plex works for a little while and then stops working and constantly says it's configuring on the TOS Control Panel. After a few hours it will start working again, only to configure again later. Is this a known issue and is anything being done to fix it?

User avatar
TMSupport
Customer Service
Posts: 1282
Joined: 13 Dec 2019, 15:15

Re: Plex Constantly Configuring After Upgrade To 4.2.13

Post by TMSupport » 10 Jun 2021, 15:25

Please refer to this link viewtopic.php?f=75&t=364
To contact our tech team, please email to support(at)terra-master.com, remember to replace (at) with @

User avatar
deejc
Posts: 97
Joined: 09 Mar 2021, 03:35

Re: Plex Constantly Configuring After Upgrade To 4.2.13

Post by deejc » 10 Jun 2021, 15:27

Good luck I ended up recreating mine last time this happened :(
F2-220 WITH 2 x WD RED 2TB

Post Reply