GitLab is an open source project for warehouse management. It uses Git as a code management tool with Web service built on this basis.
Applicable Model:
X86 models: F2-220, F2-221, F2-420, F2-421, F4-220, F4-221, F4-420, F4-421, F5-220, F5-221, F5-225, F5-420, F5-421, F5-422, F8-421, F8-422.
Not suitable for ARM models.
Compatible TOS version:
All X86 TOS versions.
Instructions:
1. Input Gitlab at Registry under Docker to search and download the suitable image.
2. Check the downloaded image and click Launch.
3. Go to Container - Details - Overview to find the tcp port as the following picture shows:
4.Input TNAS IP address:31915 (such as http://192.168.8.10:31915/) to use it.
How to install GitLab in Docker?
How to install GitLab in Docker?
To contact our team, please send email to following addresses, remember to replace (at) with @
Technical team: support(at)terra-master.com (for technical support)
Service team: service(at)terra-master.com (for purchasing, return, replacement, RMA service)
Technical team: support(at)terra-master.com (for technical support)
Service team: service(at)terra-master.com (for purchasing, return, replacement, RMA service)
Re: How to install GitLab in Docker?
Dear TMSupport,
thanks for your guideline. I was able to install gitlab via docker in my TOS F2-422.
I also was able to connect to gitlab via the provided HTTP connection and port as shown in your guideline.
I have tried to enable https connection for gitlab in docker but I'm not able to do this. Reason could be my bad knowledge about this kind of topics
Can you maybe provide also a guideline how to enable https connection for gitlab in a docker installation (i think it will be helpfull for others too, "hopefully" i'm not the only one with this problem )?
Kind regards
thanks for your guideline. I was able to install gitlab via docker in my TOS F2-422.
I also was able to connect to gitlab via the provided HTTP connection and port as shown in your guideline.
I have tried to enable https connection for gitlab in docker but I'm not able to do this. Reason could be my bad knowledge about this kind of topics
Can you maybe provide also a guideline how to enable https connection for gitlab in a docker installation (i think it will be helpfull for others too, "hopefully" i'm not the only one with this problem )?
Kind regards