Dear All,
Thank you for the NAS F5-221 with ID tnas-2cc797.
I have a Fritz box 7490 and would connect it via WIFI to the WLAN to most computers and wia LAN to a single Windows 10 computer
WIFI seems to work ok on the dongle. But when I disconnect the LAN cable, it does not go via WLAN to the rest of the Network.
After some Hours I tried the ssh interface to check the Routing and to update the Default route to WIFI
[admin@TNAS-2CC797 etc]$ ip route show
default via 192.168.178.1 dev eth1 src 192.168.178.21
169.254.0.0/16 dev eth0 scope link src 169.254.254.8
192.168.178.0/24 dev eth1 scope link src 192.168.178.21
239.0.0.0/8 dev eth1 scope link
[admin@TNAS-2CC797 etc]$ ip route del 192.168.178.0/24
ip: RTNETLINK answers: Operation not permitted
[admin@TNAS-2CC797 etc]$ ip route replace 192.168.178.0/24 dev wlan0
ip: RTNETLINK answers: Operation not permitted
But I am not successfull.
Changing the order via
Network Services => Network => Service sequence
did not help either
Any hint how to allow Routing via WIFI?
Regards
Winzergasse
WIFI and LAN access
Re: WIFI and LAN access
Please advise the detailed model information of your dongle and chipset. Please be noted that TNAS only supports a USB Wi-Fi adapter with RTL8812AU chipset.
Is it showing that the USB WiFi dongle is connected when it's plugged to the TNAS?
Is it showing that the USB WiFi dongle is connected when it's plugged to the TNAS?
To contact our team, please send email to following addresses, remember to replace (at) with @
Technical team: support(at)terra-master.com (for technical support)
Service team: service(at)terra-master.com (for purchasing, return, replacement, RMA service)
Technical team: support(at)terra-master.com (for technical support)
Service team: service(at)terra-master.com (for purchasing, return, replacement, RMA service)