moin,
i setup my new NAS with RAID5 (4*4TB). EXT4, BTRFS not available.
The RAID is ok, all HDDs are also ok, no bad blocks. No running tasks. No network activities.
But the NAS is always acting on the HDDs, sounds lihe initialising. This 9 times in a row, then a short "klack", short break, then it start for the next row. This in a never ending loop.
I think it's not good for the HDDs and it is annoying. The NAS is located on my desk.
Any ideas?
Cheers,
Michael
f4-210 TOS 4.2.31
Re: f4-210 TOS 4.2.31
Your array is synchronizing, please wait for it to complete.
To contact our team, please send email to following addresses, remember to replace (at) with @:
Support team: support(at)terra-master.com (for technical support only)
Service team: service(at)terra-master.com (for purchasing, return, replacement, RMA service)
Support team: support(at)terra-master.com (for technical support only)
Service team: service(at)terra-master.com (for purchasing, return, replacement, RMA service)
Re: f4-210 TOS 4.2.31
no, the array is synchronized since more than 4 days.
Cheers,
Michael
Cheers,
Michael
Re: f4-210 TOS 4.2.31
Go to "resources monitor > processes", check which process is running. if you can attach the screenshot here, then it can help.
To contact our team, please send email to following addresses, remember to replace (at) with @:
Support team: support(at)terra-master.com (for technical support only)
Service team: service(at)terra-master.com (for purchasing, return, replacement, RMA service)
Support team: support(at)terra-master.com (for technical support only)
Service team: service(at)terra-master.com (for purchasing, return, replacement, RMA service)
Re: f4-210 TOS 4.2.31
here it is
- Attachments
-
- 20220921185705_process.zip
- (1.84 KiB) Downloaded 13 times