TerraMaster Official Forum

It seems that IPv6 does work on an ARM device running 4.2.41

ifconfig reports eth0 as having an IPv6 address.

How do I disable IPv6?

There are no options to do this on networking section in the Control Panel.

I couldn't observe anything on the TNAS - Web UI not available, nor SSH Yeah, sorry. That should show up on the configuration page before or after restart. My time to power off is in minutes. Can't set seconds. I have a 1500 (nominal) watt ups and "use time remaining" shows as 20100 (I pr...

Apologies - 4.2.43

Any update.....

I want to be able to get the TNAS (F4-210) 4.2.21 to poweroff (note - not enter standby or safe mode). This should be a configurable behaviour but it is not. Please describe to command the TNAS uses to enter standby or safe mode. I want to be able to modify my configuration files to change this to /...

What time did you set for the TNAS to go to safe mode? or Did you use the "Until Low Battery"" setting.? Did you observe "Estimated Use Time Remaining"? I'm wondering if your TNAS actually went into safe mode. 30 seconds - And I waited for at least 10 minutes Did not set Un...

Could someone explain to me exactly what "safe mode" actually means? See this for a reasonable explanation: :twisted: https://kb.synology.com/en-ph/DSMUC/help/DSMUC/AdminCenter/system_hardware_ups?version= Observed behaviour: Pull the plug for the UPS out - It bleeps about once every 30s ...

Could someone explain to me exactly what "safe mode" actually means? I am running 4.2.x on an F4-210. Are all services stopped - Docker - Plex etc? Are all the volumes unmounted? What will be the power consumption? What is the command executed to place the TNAS into safe mode. I would rath...

So - Testing without the UPS. Enable WOL & Auto Power On Shutdown the NAS - Issue WOL - All good. Disable Auto Power On Shutdown the NAS - Remove the Power & Reconnect - Issue WAL - Doesn't work. @TMzethar - I only have one NAS so not sure why I would need to set up? Further tests to follow ...

Has this been resolved yet.

I've just run into this problem.

WOL worked after a normal shutdown.

WOL did not work after power removal and re-insertion (Auto Power On is disabled)